|
Post by CoffinFit on Mar 1, 2020 17:47:43 GMT -5
I was finishing up some more conversions, adding the diagonal state to them. I had a 1x2 that worked perfectly. But when I got to the smaller window I ran into a bit of a mess. Not sure what happened. I checked and made sure the cut numbers were the same in the blend file. It's strange because from a certain angle you actually can see the mesh, then *poof* Window File
|
|
|
Post by CoffinFit on Mar 5, 2020 13:12:48 GMT -5
OK, I will fiddle with them when I get a chance. I did create both of the cut outs and replaced both with mine which is probably why they don't work. lol
|
|